Reverse the drill bit when you re done to get the debris out of the hole.
Mount sign on brick wall.
For instance if your screws are 0 75 inches 1 9 cm long.
Forget hiring someone to hang your new custom sign for you.
Using tapcons are fairly simple.
Remember that the hole size should be slightly smaller than the diameter of the.
Align the bottom and side of the sign with the horizontal and vertical lines.
Add a screw to the middle of the masonry anchor by drilling it in.
Push the pencil into each sign mounting hole to mark its location on the surface of the wall.
Use only the screws designed for use with that masonry anchor because using a screw that s too big could damage the masonry anchor and using a screw that s too small may not provide the support you need.
Hold the sign against the face of the brick wall.
Drill slightly deeper than your screws anchors are long.
Use a carbide bit and hammer drill.
In this short video we will demonstrate just how easy it.
Using the proper diameter carbide drill bit drill a hole in the base material a minimum of 1 2 deeper than the screw.
Published on jan 28 2013.