If you suspect that the sensor is at fault you should first remove the power to the oven for a few moments and then reconnect.
Moffat oven door locked.
Replace the hinges with identical new ones and hook them back into the hinge holes in the.
If the door will not unlock at the end of the clean cycle then you may have a problem with the oven temperature sensor.
Range oven door won t unlock try the following to unlock the door.
Most electronic control ovens will display a fault code to indicate that the sensor has failed.
No matter what brand of oven you have opening the door exposes the metal hinges connecting the door to the rest of the oven.
1 remove power to the oven unplug the oven from the power outlet or flip the circuit breaker for the oven.
Clean out the oven or make the repairs you needed.
While the switch is depressed the latch motor will.
You can then reach the latches locking the hinges in place.
Do not remove whatever you used to hold the hinges in the unlocked position.
4 slide the door locking lever on front of the oven if applicable or simply just open the door.
Disconnect power to range for 30 seconds.
Heat sensitive locking control.
Disconnect power to range for 30 seconds.
Keep it unlocked until after you reinstall the door.
If door does not unlatch and you do not have food in.
This video shows the process to reset the oven door hinge should it become sprung in the removal process.
Reconnect power and see if door will unlatch.
Place the door flat on the floor with the inside face facing down.
3 set the flashing clock to the current time.
Replace the door carefully sliding it over the hinge assembly.
2 wait approximately 10 minutes and reapply power to the oven.
Your oven door may be locked because the solenoid system could be controlling it.
If the door doesn t pull up look inside the oven for screws holding the hinges in place and unscrew them.
If you have a stove that won t lock or won t allow you use the self clea.
Open the oven door.
Reconnect power and see if door will unlatch.
You may need to keep it in the proper position or else it will give you a buzzing noise when locking.